以下为U-Boot中的代码,   从注释中可以看到 真个地址映射关系：

enable_mmu:
/* enable domain access */
ldr r5, =0x0000ffff
mcr p15, 0, r5, c3, c0, 0 @load domain access register

/* Set the TTB register */
ldr r0, =mmu_table
ldr r1, =CONFIG_PHY_UBOOT_BASE
ldr r2, =0xfff00000
bic r0, r0, r2
orr r1, r0, r1
mcr p15, 0, r1, c2, c0, 0

/* Enable the MMU */
mmu_on:
mrc p15, 0, r0, c1, c0, 0
orr r0, r0, #1
mcr p15, 0, r0, c1, c0, 0
nop
nop
nop
nop
mov pc, lr

/*
* MMU Table for SMDKC210
* 0x0000_0000 -- 0x1FFF_FFFF => A:0x0000_0000 -- 0x1FFF_FFFF
* 0x2000_0000 -- 0x3FFF_FFFF => Not Allowed
* 0x4000_0000 -- 0x5FFF_FFFF => A:0x4000_0000 -- 0x5FFF_FFFF
* 0x6000_0000 -- 0xBFFF_FFFF => Not Allowed
* 0xC000_0000 -- 0xDFFF_FFFF => A:0x4000_0000 -- 0X5FFF_FFFF
* 0xE000_0000 -- 0xFFFF_FFFF => Not Allowed
*/

/* form a first-level section entry */
.macro FL_SECTION_ENTRY base,ap,d,c,b
.word (\base << 20) | (\ap << 10) | \
(\d << 5) | (1<<4) | (\c << 3) | (\b << 2) | (1<<1)
.endm

.section .mmudata, "a"
.align 14

// the following alignment creates the mmu table at address 0x4000.
.globl mmu_table
mmu_table:

.set __base,0
// Access for iRAM
.rept 0x200
FL_SECTION_ENTRY __base,3,0,0,0
.set __base,__base+1
.endr

// Not Allowed
.rept 0x400 - 0x200
.word 0x00000000
.endr

.set __base,0x400
// 512MB for SDRAM with cacheable
.rept 0x800 - 0x400
FL_SECTION_ENTRY __base,3,0,1,1
.set __base,__base+1
.endr

// access is not allowed.
.rept 0xc00 - 0x800
.word 0x00000000
.endr

.set __base,0x400
// 512MB for SDRAM with cacheable
.rept 0xE00 - 0xC00
FL_SECTION_ENTRY __base,3,0,1,1
.set __base,__base+1
.endr

// access is not allowed.
.rept 0x1000 - 0xE00
.word 0x00000000
.endr